Bathroom Plumbing Part 2

Bathroom Plumbing Part 2

The bathroom is a highly used area of the home. Learn some bathroom energy tips with this blog series.

Vancouver plumbers Plumbing and Drain Rescue continue to raise awareness of the issue with today’s lack of energy efficient homes in today’s post about energy efficient bathrooms part 2.

Faucet

There are a few ways you can reduce water usage with your faucet. Firstly, repair any leaks immediately as a leaky faucet can waste gallons of water over time. Follow our DIY, or call on our technicians to fix your faucet with expert timing! If water pressure is not a major concern in your home, installing a low-flow aerator on your bathroom faucet will also reduce your water usage. Another easy-to-adapt-to water saving tip is turning off the water when brushing your teeth instead of letting it run. This tip can also be applied to men who shave with the water running!

Showerhead

Keeping water pressure preference in mind, switching to a low flow showerhead or aerator is one of the easiest routes for saving water while you shower. If you’re the type that likes their pressure, try shortening your shower time to conserve water. A shower longer than 10 minutes uses more water than a full bath takes!

Toilet

For the technologically savvy homeowner, there are bathroom shower, toilet & sink sets available that connect the three fixtures and conserve water by using tap water to fill the cistern on the toilet. For those with less technological inclinations, or for those on smaller budgets or lack the space required, you can save energy with your toilet by installing a low-flow toilet, or a toilet with multi-flush options. Using less toilet paper will also reduce the need to “courtesy flush” and of course, there is always the Selective Flush option, which happens to rhyme (“if it’s yellow…”) For those who are less than tickled by the latter options, or for those who cannot install a new toilet fixture, say, because they are rental tenants, the easiest way to conserve water with your toilet is to report a running toilet or any leaks to building maintenance immediately, and ensure that spray foam or caulk is used to seal any holes around penetrations near your fixture, such as pipes.